May 04, 2024

Precautions for the use of hemp rope sacks

Leave a message

(1) Hemp rope is only suitable for setting lifting tools and moving and lifting of light workpieces, or hand-pulled rope for lifting workpieces, and shall not be used in mechanically driven lifting tools.
(2) The twine shall not be continuously twisted in one direction, so as not to loose or twist. When the above phenomenon is found, it should be eliminated in time.
(3) In the use of hemp rope, direct contact with sharp objects is strictly prohibited, if it cannot be avoided, it should be padded with protective objects.
(4) When hemp rope is used as a running rope, the safety factor shall not be less than 10; When used as a rope buckle, the safety factor shall not be less than 12.
(5) Hemp rope shall not be in contact with corrosive media such as acid and alkali.
(6) Hemp rope should be stored in a ventilated and dry place, not subjected to heat and moisture.
(7) The rope should be carefully checked before use, when the surface uniform wear does not exceed 30% of the diameter, the local contact does not exceed 10% of the diameter of the same section, it can be reduced according to the diameter reduction degree. If the local contact and local corrosion are serious, the damaged part can be cut off and inserted.
(8) When the rope is used in the block, the diameter of the pulley should be greater than 10 times the diameter of the rope, and the radius of the rope groove should be greater than 1/4 of the radius of the rope.

Send Inquiry