1. Prepare tools and materials:
- One piece of fine sandpaper for preliminary sanding;
- A fine abrasive cloth for fine grinding;
- A soft cloth for wiping;
- Grinding tools (either manual or mechanical).
2. Clean the sack:
Before sanding, wipe the surface of the sack with a soft cloth to remove dust and impurities.
3. Preliminary grinding:
The fine sandpaper is fixed to the sanding tool and the initial sanding is done with moderate force. Be careful to evenly press the sandpaper onto the surface of the sack to avoid uneven wear. An inconspicuous location can be selected for a preliminary grinding test to determine the force and effect used.
4. Fine grinding:
The fine abrasive cloth is fixed on the grinding tool and polished with moderate strength. Fine abrasive cloth is softer than fine sandpaper and can better smooth the surface of the sack. Also pay attention to evenly press the emery cloth on the surface of the sack to avoid uneven wear.
5. Check and repair:
After grinding, carefully check whether the surface of the sack is smooth and smooth. If it is found that there is wear, it can be polished again until it is satisfied.
6. Wipe clean:
Wipe the surface of the sack with a clean soft cloth to remove dust and abrasive residue. It can be gently wiped to make the sack look more clean and bright.
7. Precautions:
- During the grinding process, the manipulation should be kept stable to avoid uneven wear.
- Use moderate force for sanding, excessive force may cause breakage.
- Multiple gentle sanding can be used during the sanding process, rather than one strong sanding. This allows for better control of wear and tear.
- Protect your hands to avoid injury.
